Fish Aquarium

Home aquarists typically use tap water supplied through their local water supply network to fill their tanks. Straight tap water cannot be used in countries that pipe chlorinated water. In the past, it was possible to "condition" the water by simply letting the water stand for a day or two, which allows the chlorine time to dissipate. However, chloramine is now used more often and does not leave the water as readily. Additives formulated to remove chlorine or chloramine are often all that is needed to make the water ready for aquarium use. Brackish or saltwater aquaria require the addition of a commercially available mixture of salts and other minerals.
More sophisticated aquarists modify water's alkalinity, hardness, or dissolved content of organics and gases, before adding it to their aquaria. This can be accomplished by additives, such as sodium bicarbonate, to raise pH. Some aquarists filter or purify their water through deionization or reverse osmosis prior to using it. In contrast, public aquaria with large water needs often locate themselves near a natural water source (such as a river, lake, or ocean) to reduce the level of treatment. Many hobbyists use an algae scrubber to filter the water naturally.
Water temperature determines the two most basic aquarium classifications: tropical vs. cold water. Most fish and plant species tolerate only a limited temperature range: Tropical aquaria, with an average temperature of about 25 °C (77 °F), are much more common. Cold water aquaria are for fish that are better suited to a cooler environment. More important than the range is consistency; most organisms are not accustomed to sudden changes in temperatures, which can cause shock and lead to disease. Water temperature can be regulated with a thermostat and heater (or cooler).
Water movement can also be important in simulating a natural ecosystem. Aquarists may prefer anything from still water up to swift currents, depending on the aquarium's inhabitants. Water movement can be controlled via aeration from air pumps, powerheads, and careful design of internal water flow (such as location of filtration system points of inflow and outflow).