Goth Girl In Latex

Latex sheet based clothing is constructed by a three-stage process. First a pattern for a specific garment is selected, and adjusted carefully to suit the measurements supplied by the customer. Then the sheet latex is cut out on a flat board, by hand: lastly latex glue is used to join seams together. Skilled latex makers can build a stocking, shaped to match the contours of a specific person's leg, made from latex only 0.2mm thick, in under an hour. It is possible to use water-based glues such as Copydex to make latex clothes; however, the long-term durability of items made this way is somewhat dubious
Latex moulded clothing is produced by dipping a mould into a vat of liquid rubber. This is a more dangerous process than sheet latex construction because the substances that make latex into a liquid and then evaporate off the dipped mould, are toxic. The resulting clothing suffers from some shortcomings when compared with sheet-based items: mostly this is because controlling the thickness of the layer resulting from dipping is very hard, and a variation in thickness equates to a variation in stretchiness. Most moulded items suffer rapid failure for this reason - pull too hard on a thin rubber sheet and it will rip, and the varying thickness of a moulded item makes it hard to guess when too much stress is being applied. Generally, cheaper rubber garments are made on moulds that are dipped in a vat of liquid latex, and more expensive items are cut and glued together from flat sheet latex. Sheet is much stronger and more durable than moulding and carries a higher shine.
Neither moulded, nor sheet-based, latex is amenable to large scale mass production. Skilled manual artistry is an integral part of the process; this means that made-to-measure and special designs are much more accessible to the general buyer, in looking at fetish latex, than is the case with regular textiles.