McDonnell Douglas F/A-18 Hornet

Northrop had partnered with McDonnell Douglas as a secondary contractor on NACF to capitalize on the latter's experience in building carrier aircraft, including the widely used F-4 Phantom II. On the F-18, the two companies agreed to evenly split component manufacturing, with McDonnell Douglas conducting final assembly. McDonnell Douglas would build the wings, stabilators, and forward fuselage; while Northrop would build the center and aft fuselage and vertical stabilizers. McDonnell Douglas was the prime contractor for the naval versions, and Northrop would be the prime contractor for the F-18L land-based version which Northrop hoped to sell on the export market.
The F-18, initially known as McDonnell Douglas Model 267, was drastically modified from the YF-17. For carrier operations, the airframe, undercarriage, and arrestor hook were strengthened, folding wings and catapult attachments were added, and the landing gear widened. To meet Navy range and reserves requirements, McDonnell increased fuel capacity by 4,460 pounds (2,020 kg), by enlarging the dorsal spine and adding a 96 gallon fuel tank to each wing. A "snag" was added to the wing's leading edge and stabilators to prevent a flutter discovered in the F-15 stabilator. The wings and stabilators were enlarged, the aft fuselage widened by 4 inches (102 mm), and the engines canted outward at the front. These changes added 10,000 lb (4,540 kg) to the gross weight, bringing it to 37,000 lb (16,800 kg). The YF-17's control system was replaced with a fully digital fly-by-wire system with quadruple-redundancy, the first to be installed in a production fighter.
Originally, it was planned to acquire a total of 780 aircraft of three variants: the single seat F-18A fighter and A-18A attack aircraft, differing only in avionics; and the dual-seat TF-18A, which retained full mission capability of the F-18 with a reduced fuel load. Following improvements in avionics and multifunction displays, and a redesign of stores stations, the A-18A and F-18A were able to be combined into one aircraft. Starting in 1980, the aircraft began to be referred to as the F/A-18A, and the designation was officially announced on 1 April 1984. The TF-18A was redesignated F/A-18B.