Paper Trees By Yuken Teruya From Japan

As a general standard, tree girth is taken at 'breast height'. This is cited as dbh (diameter at breast height) in tree and forestry literature. Breast height is defined differently in different situations, with most forestry measurements taking girth at 1.3 m above ground, while those who measure ornamental trees usually measure at 1.5 m above ground; in most cases this makes little difference to the measured girth. On sloping ground, the "above ground" reference point is usually taken as the highest point on the ground touching the trunk, but some use the average between the highest and lowest points of ground. Some of the inflated old measurements may have been taken at ground level. Some past exaggerated measurements also result from measuring the complete next-to-bark measurement, pushing the tape in and out over every crevice and buttress.
Modern trends are to cite the tree's diameter rather than the circumference. Diameter of the tree is calculated by finding the medium diameter of the trunk, in most cases obtained by dividing the measured circumference by π; this assumes the trunk is mostly circular in cross-section (an oval or irregular cross-section would result in a mean diameter slightly greater than the assumed circle). Accurately measuring circumference or diameter is difficult in species with the large buttresses that are especially characteristic in many species of rainforest trees. Simple measurement of circumference of such trees can be misleading when the circumference includes much empty space between buttresses.
One further problem with measuring baobabs Adansonia is that these trees store large amounts of water in the very soft wood in their trunks. This leads to marked variation in their girth over the year (though not more than about 2.5%), swelling to a maximum at the end of the rainy season, minimum at the end of the dry season.
The stoutest living single-trunk species in diameter are: